DIY Difficulty Level

Navigate: Main_Page ...Do It Yourself ...Halo HID Headlight Installation

OverviewModels and YearsTools NeededInstructionsSimilar PagesExternal Links


Models and Years:
Halo HID Headlight Installation/Models

Halo HID Headlight Installation/Overview


Halo HID Headlight Installation/Tools


Halo HID Headlight Installation/Instructions


Models and Years:

Alright, it's probably one of the easiest things I've ever done. Took me 10 minutes to do both headlights... outside, in the cold windy darkness. Holding a flashlight. I didn't time how long it took to drill the holes, because I did that while "working" using the company drill press. Probably took 20 seconds total wink1.gif Complete install was done on my 15 minute dinner break (night shift).


  • none at the moment


First - drill a hole in your headlight cover. About 1/4 inch... make sure the grommet will fit in there. I had to drill a second hole for the red and blue wires to go through. You may not have to, it depends on your setup.

These pictures will pretty much explain everything else. The hardest part was latching the bulbs in with that stupid metal clamp thingie we have. It's always a PITA for me changing bulbs. Just force it in and it'll be fine.

In the first picture, I put a label on pretty much everything. I can't explain it any more than that really.


In the second picture, pay attention to where the holes are drilled. Not a big deal really. Follow the wires to where they connect to the ballast. It's really very easy, just plug the connectors in the only place they can connect.


In the last picture, it shows the ballast behind the battery. I bolted it to a hole left open from when I removed my factory intake boxes. It works perfect. The wires run around my battery to the headlights with no problem.


Community content is available under CC-BY-SA unless otherwise noted.